Configure a network simulated in the Packet Tracer file provided. The IP addressing assignments are already done for you. Verify that all configurations are operational and functioning according to the requirements below. Create and maintain your configurations as text file(s) independently of Packet Tracer. Note that the tasks below are mostly switch-related, so you are really only configuring the portion of the network labelled ‘Area 12’ for now. Another set of tasks later in semester will address routing and management, and will involve the other areas of the topology. You will need to submit your work covering switching, routing and management tasks as a single submission in week 11, before the skills exam. Complete the following tasks: 1. Configure EtherChannel (using LACP) between pairs of switches that are connected to each other by more than one link. 2. Configure VLANs, VTP, and VLAN trunks on S1, S2, MS1 and MS2 as appropriate. a. Note on MS1 and MS2, you may want to use the command ‘switchport trunk encapsulation dot1q’ before setting the trunk mode. b. VLAN 77 is the management VLAN, VLANs 5 (sales) and 6 (engineering) carry user traffic. Make MS1 and MS2 both VTP servers, and S1 and S2 VTP clients, for the VTP domain ‘wayside’ (that’s the name of the company). c. Assume odd-numbered PCs (PC1, PC3) are on VLAN 5 and even-numbered PCs (PC2, PC4) are on VLAN6 3. Configure PVST, ensuring that MS1 is primary root bridge for VLANs 77 and 5, and secondary root bridge for VLAN 6. MS2 should be primary root bridge for VLAN6, and secondary root bridge for VLANs 77 and 5. 4. Configure the switches MS1 and MS2 to provide default gateway services to end hosts on VLANs using HSRP (and with the addresses 172.20.1.46, 172.20.1.54, and 172.20.1.62 for the virtual router for VLANs 77, 5, and 6 respectively).
The post Configure a network simulated in Packet Tracer file appeared first on My Assignment Online.