Limited Offer Get 25% off — use code BESTW25
No AI No Plagiarism On-Time Delivery Free Revisions
Claim Now
Prices start at $5 per page · plagiarism-free papers · free revisions for 14 days 24/7 support: support@bestwriters.com
Uncategorized

an address and word count to the memory

  • Posted
  • Authoradmin
  • Length473 words
  • Reading time3 min
Write My Assignment FREE

Given a memory and an I/O device on a bus as shown below:

   64 bit wide bus, synchronous, 50MHz clock
==============================================================
              |                               |
  address and | two 32-bit data   address and | two 32-bit data
  word count  | words sent        word count  | words received
  received in | in one clock      sent in one | in one clock
  one clock   |                   clock       |
              |                               |
  +-----+-----+-----+-----+             +-----+-----+
  |     |     |     |     |Registers    | I/O device|
  +-----+-----+-----+-----+             | receiving |
  | RAM memory that is    |             | word-count|
  | four 32-bit words wide|             | words of  |
  | and has output        |             | data      |
  | registers for four    |             +-----------+
  | words                 |
  +-----------------------+

The system operates by the I/O device sending an address and
word count to the memory. The memory uses the address to start
a memory access that brings four 32-bit words into the memory
output registers. In parallel, [the memory starts the access of
the next four words] and [sends two words on the bus, then two
more words on the bus, then a bus idle, then another bus idle].
Thus, the bus actions are overlapped with the next memory access.
Note that the bus may be used by other devices between these
four clock operations on the bus.

The memory access is non uniform. Upon receiving an address,
the first memory access takes longer than the following
memory accesses. This happens in some memories due to the
extra time to charge word or block select lines. Once started
with an address and word count, the memory puts data on the bus
until the word count is satisfied.

For this exercise the first memory access requires 5 clocks
and each additional memory access in the same transaction requires
4 clocks.

A bus transaction starts with the sending of an address and
word count. The transaction ends when the last word and two idles
are received by the I/O device. The transaction time does not
include the one clock to send the address and word count.

Bandwidth is measured in megabytes per second.
The address and word count are not included in the byte count
and not included in the time.

For the I/O device to get 512 words when the I/O device uses
4 as the word count. (512 words is 2048 bytes)

a) Compute the total time from after receipt of the address to the
end of the last transaction.
b) Compute the transactions per second.
c) Compute the bandwidth.

For the I/O device to get 512 words when the I/O device uses
32 as the word count.

d) Compute the total time from after receipt of the address to the
end of the last transaction.
e) Compute the transactions per second.
f) Compute the bandwidth.

Show your work as formulas or as tables.
Be consistent. Use either clock counts or nanoseconds.
Obviously a 50MHz clock uses 20 nanoseconds per clock.

The post an address and word count to the memory appeared first on My Assignment Online.

Plagiarism Free Assignment Help

Expert Help With This Assignment — On Your Terms

✓ Native UK, USA & Australia writers ✓ Deadline from 3 hours ✓ 100% Plagiarism-Free — Turnitin included ✓ Unlimited free revisions ✓ Free to submit — compare quotes

admin

Academic writer and editor at BestWriters.

Get your paper off your plate tonight

Post your instructions for free. Prices start at $5 per page.

Place an order